#Mediatube center install
DO NOT attempt to install Media Tubes® HO with functional defects on-site. Report any functional defect found to your nearest Traxon Technologies office.Check for any abnormalities with the control signal. Perform functional check on all Media Tubes® HO and inspect cables and Mounting Bracket for any damage.Connect Media Tubes® HO with LED Engines in the daisy-chain manner outlined in the System Diagram to form large installations.Measure the correct distances for Mounting Brackets.Plan for any possible bending of cables (see Section 2.2.2).If the Mounting Bracket method of installation is used, it is recommended to fix it to the installation surface before the Media Tube® HO is secured to the bracket
![mediatube center mediatube center](http://palami.eu/file/1422303049_su_idman_1.jpg)
NOTE: Water ingress incurred due to cable twisting or excess cable bending will not be under warranty by Traxon Technologies. Minimum Cable Bending and Non-Bendable Length requirement It is recommended to install lead cables through conduits/trunking. To reduce stress induced on Media Tube® HO lead cables, please adhere to the Minimum Bending Radius of 10mm (0.4”) and the Non-Bendable Length of 20mm near the connector. If the installation is to be left uncompleted overnight, place all non-connected LED Engines and Media Tubes® HO in an indoor environment.Įnsure all the Interconnection Cables, Media Tubes® HO and LED Engines are initially stored in a dry area to guarantee the complete sealing of the system from water before installation. Ensure all pre-installation checks laid out below have been followed.Take care not to damage cables/connectors during pre-installation checks. Perform functional check of Media Tubes® HO.Prepare cables and all necessary accessories (Mounting Brackets, Waterproof Quick Lock End Caps etc).Number of standard LED Engines to be used.
![mediatube center mediatube center](http://palami.eu/file/Untitled_design_2.png)
There are two mounting methods to consider, plan mounting distances accordingly for whichever method is required.Distance between each Tube for thermal expansion and maintaining pixel pitch.DMX512/e:pix controller to be used to control the Media Tubes® HO.The number of Media Tubes® HO and appropriate LED Engines.Please consult your local Traxon office or authorized agent for necessary aid. Appropriate cable lengths (cable gauges described in below diagram).
![mediatube center mediatube center](http://palami.eu/file/1795551_734332376600591_668214228_n_1.jpg)